Turn on the tap and check that enough water comes out of it.
Electrolux washer no water message.
Replace the inlet valve assembly.
You ll need to pull the washer forward and turn the water off to the washer.
The most common reasons for replac.
Pressure switch checks good.
If there is a filter in the water valve where the inlet hose screws into the washing machine it should be also clean.
Did the water fill stop.
Is the washer leaking water.
Pressure switch checks bad.
If this does not help and the error code reappears the inspector of the laundry must be contacted.
If not then something was setup wrong like a plug not being removed.
If they are clogged flush them out.
Turn the water on to make sure you have good water pressure from both hot and cold water lines.
Pull out the dispenser drawer and press down on the rear lock tab.
Taps out to e21 after a few minutes of that.
Turn the water off and remove the hoses from the back of the washer.
I tried a hard reset and spin only and it did the usual couple turns of the barrel here and there drain pump ran almost constant and taps out.
Clean the filter in the inlet hose next to the tap.
Check the little filter screens where the fill hoses connect to the back of the washer.
Run a mini wash and place the hose into a bucket to see if water is coming out.
Go to step 6 no.
Water leak in tub or air leak in air bell.
Replace the pressure switch.
If everything checks good you just need to replace your electronic water valve because it has failed and isn t letting any water into the washer.
Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket.
If the compartment or inserts are stained allow them to soak in 3 4 cup of liquid bleach and a gallon of hot water before rinsing.
Whether your washing machine is leaking water the door isn t latching or something else has gone wrong we re here to help you identify the cause and make the repair so you can feel good about how handy you are and your laundry can feel good about being clean.
The error code is displayed if the user presses the start button while the vacuum switch is already closed.
Sometimes you can hear water gurgle out sometimes you can t.
There is a sensor stating no water is passing it.
Replace the pressure sensor.
You should be able to fill a 10 litre bucket in about a minute.
Remove some of the clothes close the door and press the start button.
If this did not correct the problem go to step 7.
Replace the main control board.
Remove the detergent compartment and take out the inserts then rinse them thoroughly under hot tap water to wash away residue and buildup.
You can hear the drain pump running.
This video provides step by step repair instructions for replacing the water inlet valve on an electrolux washing machine.
Please register to post and access all features of our very popular forum.
If it s time to repair your electrolux washing machine then it s time to consult repair clinic for the troubleshooting help you need.
