Temp and lamp flashing red lights original post.
Epson projector lamp light blinking red.
The fans stay on for about 2 minutes then the projector shuts down.
If the problem persists unplug the projector and contact epson for help.
The projector has an internal problem.
Note if thelights display a pattern not listed in the table above turn theprojector off unplug it and contact epson for help.
Flashing red red flashing red.
Lamp has a problem.
Reseat or replace the lamp as necessary.
During this the red temp light flashes.
Signs of a burnt out lamp include.
Although lamp life varies from projector to projector all lamps need to be replaced at some point making this one of the most common projector issues.
If the light is flashing red or orange you need to replace the lamp.
Reseat or replace the lamp as necessary.
If overheating continues replace the air filter.
Inspect the lamp light.
Clean or replace the air filter.
If the projector turns on but the image doesn t appear your lamp may be burnt out.
Stop using the projector disconnect the power cord and contact epson for further troubleshooting.
Check to see if the lamp is burned out broken or installed incorrectly.
Some users have plugged air filters and when the filter is cleaned the problem is corrected.
If operating the projector at high altitude turn on high altitude mode.
Check to see if the lamp is burned out broken or installed incorrectly.
If operating the projector at high altitude turn on high altitude mode.
Projector light status the lights on the projector s control panel indicate the projector status and let you know when a problem occurs.
Check the status and color of the lights and look for a solution in the.
Turn the projector off unplug it and contact epson for help.
If the image being projected is discolored or dim the lamp may burn out soon.
Epson s online help for a case like this places the blame on the user and poor maintenance.
Epson 3010 movie projector projector some time shows a green picture a few seconds then is off i think is overheating.
If the problem persists unplug the projector and contact epson for help.
